John Miller

Al Noor Contracting LLC, Dubai, United Arab Emirates

• Supervised construction activities for a mixed-use development including two residential towers, podium parking, and retail areas.
• Reviewed structural drawings, coordinated RFIs, and followed consultant comments until closure.
• Prepared weekly progress reports, look-ahead schedules, material requests, and manpower plans.
• Coordinated concrete pours, steel reinforcement inspections, formwork checks, waterproofing, blockwork, plastering, and finishing interfaces.
• Monitored subcontractor performance and ensured work complied with specifications, approved shop drawings, and project quality plans.
• Reduced rework by improving inspection checklists and coordinating earlier between site, QA/QC, and MEP teams.

Gulf Infrastructure Consultants, Abu Dhabi, United Arab Emirates

• Managed site execution for road, stormwater drainage, utility corridor, and pavement rehabilitation works.
• Checked levels, alignments, excavation depths, bedding layers, compaction results, and asphalt works with the survey and lab teams.
• Prepared daily site reports, inspection requests, quantity takeoffs, and payment measurement sheets.
• Coordinated with authorities for permits, traffic diversions, and utility protection requirements.
• Supported value engineering discussions that optimized drainage routes and reduced construction delays.

Levant Engineering Office, Amman, Jordan

• Assisted in structural analysis and design of residential villas, small commercial buildings, retaining walls, and reinforced concrete slabs.
• Prepared structural calculation notes, bar bending schedules, and drawing markups under senior engineer supervision.
• Visited sites to inspect reinforcement, foundations, columns, beams, slabs, and concrete quality before casting.
• Used AutoCAD and structural design software to support design revisions and authority submission packages.

University of Jordan, Amman, Jordan

GPA: 3.42 / 4

Focused on structural analysis, reinforced concrete design, geotechnical engineering, transportation engineering, hydrology, and construction management.

Dubai Municipality Training Center, Dubai, United Arab Emirates

Professional development courses in construction safety, inspection procedures, and project documentation.

Tools: Reinforced Concrete, Post-tension Slabs, QA/QC, Primavera P6

Site supervision for reinforced concrete structure, podium parking, finishing coordination, and consultant inspections for a high-rise mixed-use project.

Tools: Drainage, Utilities, Roadworks, Surveying

Execution support for stormwater network improvements, manholes, pipe bedding, road reinstatement, and asphalt works.

Tools: ETABS, SAFE, AutoCAD, ACI Code

Prepared structural design support, reinforcement details, and site inspection notes for a private residential villa.

Issuer: Project Management Institute Authorized Training Partner

Covered project planning, risk management, cost control, stakeholder communication, and schedule monitoring.

Issuer: Autodesk

Professional drafting and construction drawing documentation.

Issuer: Autodesk Training Center

Modeling structural elements, coordination views, schedules, and documentation.

Issuer: OSHA Authorized Training Provider

Construction site safety, hazard identification, fall protection, and emergency procedures.

Issuer: Engineering Training Institute

Introduction to contract administration, claims, variations, and engineer instructions.

Venue: Company Knowledge Base

Internal technical note on reducing rework through early interface reviews.